国产一区二区自拍视频_亚洲国产人成在线观看69网站_69xx日本欧美极品_三上悠亚中文字幕_18女下面流水不遮图免费图_a篇免费视频在线观_欧日韩精品一二三_免费在线观看日韩aⅴ片_变态另类色中色第一页_特级婬片国产高清

When processing injection molded parts, we often encounter unnecessary defects due to small reasons, which can cause some trouble for our injection molding process. Among these defects, the most common one is crack defect. So, what are the reasons for crack defects in the processing of injection molded parts?

1. Improper use of release agents, uneven cooling after product demolding, etc.

2. The raw material plastic has pollution, volatiles, or poor drying;

3. Short holding and injection time, long or short cooling time;

4. Improper demolding design, small demolding slope, thin product walls with sharp corners and notches, resulting in stress concentration;

5. The proportion of recycled materials added to raw materials is large, resulting in large directional shrinkage of raw materials or uneven distribution of fillers;

6. Improper forming conditions, high stress, and poor ejection;

7. Low or uneven mold temperature, slow injection speed, and low pressure;